Johnson Pump SPX Viking Power 32 Manual De Instrucciones página 9

Self-priming
The pump is self-priming up to 2,5 and 5 m
respectively (Viking Power Vacuum)
Dry running
The pump can be run dry without any harm.
It will however unnecessary reduce your
battery power.
Hand cranked power
The pump can in case of emer-
gency such as power failure be
run with the enclosed hand-
cranked power source.
NOTE: Make sure that the
pump is disconnected from the
power supply while the motor is working
as a power generator.
NOTE: Do not run the pump with power
supply and the crank mounted at the same
time.
Winterizing
Drain the pump from water by pumping
it until it primes air and there is no fluid
coming from the outlet.
Original instructions
Service instructions
Change of diaphragm
1. Remove the two screws that hold the
clamps and remove the clamps.
2. Remove the pump housing.
3. Remove the screw that holds the
diaphragm and the diaphragm washer.
4. Remove the diaphragm and the
diaphragm washer.
5. Mount the new diaphragm and the new
diaphragm washer with the new screw.
6. Assemble the pump housing and the
clamps.
Change of pump housing
1. Remove the two screws that hold the
clamps and remove the clamps.
2. Remove the pump housing.
3. Assemble the new pump housing and
the clamps.
Cleaning the anti-drainback valve(s)
1. Remove the two screws that hold the
clamps and remove the clamps.
2. Remove the pump housing.
3. Inspect the rubber anti-drainback valve
and remove any debris.
4. Unscrew the connections and inspect
the outlet anti-drainback valves (Viking
Power Vacuum).
5. Assemble the connections, the pump
housing and the clamps.
Waste management / Recycling
Dispose of the product in accordance with
existing regulations.
Where appropriate, dismantle and sort the
product by its material fractions.
> English
9