Mounting The Pump - Aqua Medic aCone 3.0 EVO Manual De Instrucciones

DC Runner Control
The included DC Runner
The power can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press
the button „FEED", the output will stop for 10 minutes. Controller, transformer, plugs and sockets
have to be kept dry.
Fig. 3: DC Runner Control

3.3. Mounting the pump

In any case, it must be prevented that the pump runs dry since this would destroy the bearings
after a short period.
The pump head can be fitted in different positions to the pump housing. It has to be fitted in such a
way that the pressure fitting points to the side, as shown in Fig. 1, No. 13.
After setting up the pump, please ensure you can always reach the power plug easily.
Safety advices
The pump is constructed for indoor use only.
The connection cable and the power plug must not be changed. If the
power cable is damaged, the pump must be scrapped.
3.4. Maintenance / Cleaning of the pump
Depending on contamination, the pump has to be cleaned occasionally, at least in two-month
intervals, if necessary more frequently.
First of all, remove the retaining plate. Then, take off the pump head (Fig. 2, No. 7). Now, the
complete impeller (Fig. 2, No. 5) can be taken out. Caution: This part is tight fit and has to be
removed carefully so as not to break the ceramic shaft. It can be cleaned under running water and
then be re-assembled.
10
Control is switched between power supply and pump to adjust the output.