Shortening The Led Strip - LIVARNO LUX HG02044 Instrucciones De Utilización Y De Seguridad

You may repeated press the
or to adjust the ligh-
ting area of the connected
LED strips (max. 10m).
After setting the lighting area,
press button and then
w/cw
press the
the luminosity.
Shortening the LED
strip (see Fig. C)
The LED strip
2
to size. It can be cut with scissors
at the marked position, as shown
in Fig. C. The trimmed sections
can then be connected as shown
in figure C.
LIFE BY ELECTRIC SHOCK!
Before performing any work, first
disconnect the product from the
mains power. Unplug the power
supply from the socket.
3
Connect as described below:
Remove the protective film
from the double-sided adhe-
sive strip at the ends of the LED
strip sections being connected.
or to adjust
may be trimmed
DANGER TO
Then firmly press the end of
the one LED strip onto the pins
on the connector
pierce the strip conductor of
the LED strip.
Note: Be sure to match up
the VGGD mark on the
connector with the VCC-
GND-GND-D0 and VCC-
GND-GND-DI mark on the
LED strip.
Then push a plastic clip
onto this new connection
from the top.
Note: Be sure the plastic
clips lock in to establish a
secure connection.
Repeat this process to estab-
lish a contact for the other
end of the connector.
Note: Unlike the LED strip,
the connector can be moved
in any direction:
The product
has delicate solder points.
Do not route the LED strip
around corners and do not
kink. The solder points may
otherwise be damaged, dis-
rupting the functionality of
the LED strip.
so they
1
11
GB/IE 25