Swing-N-Slide Chesapeake Manual Del Usaurio página 27

Ocultar thumbs Ver también para Chesapeake:
Tabla de contenido

Publicidad

Q. Swing Beam Drill Locations
1. Flip 3'' x 5-1/2'' Swing Beam so Carriage Bolts point downward as shown in (Fig. 16).
2. Install the swing hanger onto the beam by sliding over two carriage bolts (refer to (Fig. 15) for placement) and
apply two washers and two loc-nuts per Swing Hanger. Make certain to orient swing hanger as shown
in (Fig 16).
Note: When attaching D-Ring, make certain threads are pointing up. This will help keep the D-Ring from
loosening over time.
4. Repeat for all four hangers.
WASHER
LOC-NUT
27
Fig. 16
WASHER
LOC-NUT

Publicidad

Tabla de contenido
loading

Tabla de contenido