Swing-N-Slide Chesapeake Manual Del Usaurio página 41

Fig. 32
1'' Truss Head Screws
X2
per joint
Double check to make
sure structure is square
Picnic Bench
1. Using (2) 'Boomerang brackets' Install 2'' x 4'' boards
as shown in (Fig. 32). Sandwich 'Boomerang Bracket'
between horizontal and vertical 2'' x 4''s. Make certain
bottom edge of Boomerang Bracket touches the ground.
2. Attach 1'' x 4'' boards as shown in (Fig. 32a). Make
boards flush with end of 2'' x 4'' support with no gap
inbetween.
3. Attach Picnic Table support centered underneath the
Picnic table as shown in (Fig. 32b).
(3)
(2)
Boomerang
Brackets
1''Truss Head
screw
Fig. 32a
2-1/2'' screw
Fig. 32b
1'' x 4'' x 6-1/4''
UNDER DECK VIEW
1-1/4'' screw
41
(2)
2-1/2'' Deck Screws
per joint
(1)
1-1/4'' Deck Screws
per joint