Installation
Instructions and Wine Chiller
Questions? Call 800.GE.CARES (800.432.2737)
GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
instructions for future reference.
WARNING
•
This appliance must be properly
• If you received a damaged beverage center or
wine chiller, you should immediately contact your
dealer or builder.
• Skill Level – Installation requires basic
mechanical skills. Proper installation is the
responsibility of the installer. Product failure due
to improper installation is not covered under the
GE Appliance Warranty.
49-60466-6
Beverage Center
Save these
Observe all
Be sure to leave these
or
Visit our Website at:
PRODUCT CLEARANCES
The beverage center and wine chiller is factory set
When installed in a corner:
• Allow 4" min. clearance on the hinge side for the
10" Minimum
to Wall
110°
• The door swing is reversible on all models. If
desired, change the door swing before installation.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the door.
•
it will not run often enough to maintain proper
temperatures.
•
will not perform properly.
•
to water (rain, etc.) or direct sunlight.
• These products are not designed to be stacked
one over the other.
21-5/8"
23-5/8"
90°
4" Minimum
to Wall