Use Of The Accessory - WEG CFW100 - IOADR Guía De Instalación, Configuración Y Operación

Módulo de expansión de i/o y control remoto infrarrojo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Infrared Remote Control and I/O
Expansion Module
Param. Description
P375
NTC
Temperature
(*)
P840
Control
Key Status
(*)
Quick
P842
view 1 IR
(*)
Quick
P843
view 2 IR
(*)
NOTE!
(*) Parameters available only when the
accessory is connected.

6 USE OF THE ACCESSORY

For the proper operation of the CFW100 frequency
inverter with the CFW100-IOADR accessory, some
procedures must be observed:
1. The remote control must be directed to the cable end
(IR receiver), as shown in
2. The maximum distance between the remote control
and IR receiver is eight meters.
NOTE!
Before using the infrared remote control,
remove the battery protection in the lower
part of the control.
Periodically check the need to replace the
remote control battery.
The functionalities of the remote control keys can be
seen in
Table 4 on page
be seen in
Figure 1 on page
10 | CFW100
Adjustable Range
0 to 100 °C
2 or 802 = On/Off
6 or 806 = Arrow down
8 or 808 = Arrow up
9 or 809 = Forward/Reverse
B or 80B = Programmer
F or 80F = Special
Function 01
10 or 810 = Special
Function 02
11 or 811 = Special
Function 03
0 to 999
0 to 999
Figure A2 on page
11. The remote control can
11.
Factory
Proper.
Setting
ro
ro
2
375
30.

Publicidad

Tabla de contenido
loading

Tabla de contenido