Solo 117 Manual Del Usario página 23

Castrol-Oil TT
50:1(2%)
1000 cc (1 Liter)
5000 cc (5 Liter)
3
10000 cc (10 Liter)
Initial starting instructions:
For the first 5 tank fulls, avoid over-reving the
engine when no load is applied. Also when
using standard 2-cycle oil, we recommend a
ratio of 25 : 1 (4%).
- Do not use near open fires or while
smoking. (illustration 2).
- Let the engine cool off, prior to refueling.
- Gasoline may contain harmful solvent-
like substances. Avoid skin and eye
contact. Wear protective gloves when
refueling. Change protective clothing
often. Do not inhale gasoline vapors.
- Do not spill any gasoline or oil. Clean
brushcutter immediately if
gasoline or oil is spilled. Avoid spilling
gasoline on clothing. Change clothing
immediately in case of spills.
- Be careful that fuel or oil does not spill
onto the ground (illustration 2) (environ
mental protection). Use cardboard or a
mat for protection.
- Do not refuel in enclosed areas. Fuel
vapors collect near the ground (danger
of explosion) (illustration 2).
- Transport and store gasoline and oil only
in authorized and marked containers.
Make fuel and oil inaccessible to
children.
- Take care not to inhale exhaust fumes.
Do not use the brushcutter in enclosed areas.
Handling gasoline requires great
care. Be sure to observe all safety
recommendations!
Refuel only with the engine off.
- Thoroughly clean dirt from around the
fuel tank cap to keep it from falling in
the tank when the cap is removed.
- Be careful when opening the fuel tank lid.
Any excess pressure in the tank may cause fuel
spray.
Premium 2-C-Oil
25:1(4%)
20 cc 40 cc
100 cc 200 cc
200 cc 400 cc
- Remove fuel tank cap and fill tank to the
lower edge of the filler pipe.
- Refuel carefully to avoid spilling gasoline
mixture or oil.
- Firmly close fuel tank cap.
Storage
The brushcutter is to be stored in a dry area
and should be protected with a cover.
Special engine preservation is not necessary when
using "Castrol Super TT" or Superior 2 cycle oil.
The fuel tank needs to be emptied when the
brushcutter is stored for an extended time.
Assembly Instructions
Installation Instructions
Operating Instructions
• Assemble loop handlebar
• Bicycle handlebar
• Bicycle handlebar adjustment
• Installing debris shield
• Assembly and changing cutting
Attachment
• Kick-back danger
• Installation of nylon head
• Adjusting carrying strap
• Starting with Loop handle design
• Start and Stop
• Carburetor settings
9 Installing loop handlebar
(Model 117 / 121 L / 129 L)
Attach safety bar (1) to loop handle and secure
with bracket (2).
The loop handle can be adjusted forward by
approx. 25mm, if required for balance. For
special applications, such as for trimming
edges, the loop handle can be moved 90
degrees.
To lock the loop handle in place, simply hand
tighten knurled nut (3) and secure with lock
lever (4).
Note: The safety bar acts as a barrier to
prevent accidents. Please ensure the bar is
fitted on the correct side for either right or
left handed operators.
23