Technical Data; Limits Of Use - Beninca PONY Manual De Instrucciones

Technical Data, dimensions and limits of use

TECHNICAL DATA

Control unit power supply
Motor power supply
Absorbed power
Absorption
Torque
Operative intermittence
Opening speed
Protection rating
Functioning temperature
Driving gear for rack
Noise
Weight
DIMENSIONS
Fig. 1 indicates the main clearance dimensions of the gear motor
complete with guide.
The measurements are expressed in millimetres.
If the rack is already present on the gate, it is important to
consider the measurement of the driving gear (89mm), for the
correct coupling between the rack and the driving gear.
If the rack is already present, check that it is well-fixed,
in good state, perfectly horizontal and that the pitch
corresponds to that of the driving gear, M4, i.e. about
12 mm between one notch and the next.

LIMITS OF USE

PONY can be used exclusively for residential sliding gates with
a maximum weight of 400 kg.
The length of the leaf is not a restriction. In all cases it is recom-
mended to install PONY on leaves with length exceeding 6m.
14
PONY
230 Vac (PONY)
115 Vac (PONY 115)
50/60 Hz
24Vdc
80 W
0,6 A
9 Nm
30%
10 m/1'
IP44
-20°C / +50°C
M4 Z14
<70 dB
6,8 kg
120
185
The materials with which the door is built, the
state of maintenance and particular conditions
of use can reduce the values indicated.
In no case can the installation of PONY be con-
sidered a solution for opening inefficient doors.
120
185
Fig.1
215
295
2