How To Assemble Your Ceiling Fan - Fanimation Torto FP7900 Serie Manual Del Propietário

Ventilador de techo

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Electrical and Structural Requirements (Continued)

Deep box with brace (Figure 3)

Paired with a deep box, this hanger is meant to span

between two joists and takes the place of wooden

blocking.

WARNING

To reduce the risk of fire, electric shock, or personal

injury, mount to outlet box marked acceptable for fan

support of 15.9 kg (35 lbs) or less and use mounting

screws provided with the outlet box. Most outlet boxes

commonly used for the support of luminaires are not

acceptable for fan support and may need to be

replaced, consult a qualified electrician if in doubt.

If your fan is to replace an existing light fixture, turn

electricity off at the main fuse box at this time and

remove the existing light fixture.

WARNING

Turning off wall switch is not sufficient. To avoid

possible electrical shock, be sure electricity is

turned off at the main fuse box before wiring. All

wiring must be in accordance with National and

Local codes and the ceiling fan must be properly

grounded as a precaution against possible electrical

shock.

WARNING

To avoid fire or shock, follow all wiring instructions

carefully. Any electrical work not described in these

instructions should be done or approved by a

licensed electrician.

1. Remove the Clevis Pin, Hairpin Clip, Hanger Ball and

Pin by loosening the setscrew in the Hanger Ball. Retain

the Clevis Pin, Hairpin Clip, Hanger Ball and Pin for

reinstallation. (Figure 1)

2. The fan comes with blue, black, white 80" wires.

a r

e t

w t

t s i

through the Downrod.

NOTE: You will be using either the 6" or the optional

downrod purchased separately.