Connecting Rain/Moisture Sensor - Nelson SmartZone EZ Serie Guía De Instalación Y Programación

INSTALLATION INSTRUCTIONS

Connecting Rain/Moisture Sensor

The SmartZone
port on the SmartZone
2). To install a sensor, remove the factory-installed jumper wire from the sensor connector on the
terminal strip and insert the sensor wires. Refer to the sensor manufacturer's instructions for
specific installation details.
If a sensor has suspended watering, the sensor indicator segment will appear on the LCD
The symbol will go off when the sensor has dried out or when the controller is set in one of the
manual modes (see pages 23-25). The SmartZone
selected program.
EZ is equipped to operate a sensor with normally-closed leads. The sensor
TM
EZ is the first tool-less connector on the interconnect board (see Figure
TM
FIGURE 2
Sensor Port
TM EZ will resume operation based on the
.
7