Multilaser Som Automotivo Style Manual Del Usuario página 28

16. Replace the Battery of IR Handeset
16. Replace the Battery of IR Handeset
Replace the Battery
When the operational range of the remote control becomes short or non-functions while operating.
Replace a new CR2025 battery. Make sure the battery polarity before replacement.
1. Pull out the battery holder while pressing the stopper 1
2.
Pull the button type battery (+) mark upward into the battery
holder
3. Insert the battery holder into the remote controller
52
17. Install the Unit (DIN front mount)
17. Install the Unit (DIN front mount)
Installation Instructions
driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
Remove the front panel
Press "REL" button, This part plastic will be detached.
Please refer to the left of the test images.
NOTE:
With the panel removed, the system will stop all
work, inorder to operated this system re-install
the parel
Install the front panel
The Detached part install back into the unit the
installation direction should be from down to up.
Please refer to the left of the test images.
NOTE:
The play with continue from the point it
stopped in the media last time.
NOTE:
Please don't on the control panel with your finger, if may cause the
connector contact failure installation direction should be from down to
up, if connectors dirty application of clean soft cloth to wipe clean.
Note:
Choose the mounting location where the
unit will not interfere with the normal driving
function of the driver.
- Before finally installing the unit, connect
the wiring and make sure that the unit
works properly.
- Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
- Install the unit where it does not get in the
53