Novik Neo NVK 16M USB Manual De Instrucciones página 6

INSTALLATION
Cable connections
You will need a great number of cables for the different connections of the console. The pic-
tures below show how to connect them. Be sure to use only good quality connectors.
WARNING!
Do not use unbalanced XLR connectors (pins 1 and 3 connected between them) in micro-
phone inputs if you are going to use Phantom Power.
TROUBLESHOOTING
The unit does not turn on • Is the unit connected to a proper alternate
It does not sound. • Are the microphones and other sound
• Are the gain controls and faders correctly
The sound is weak, distorted or noisy. • Are the gain controls and faders correctly
• Are two different instruments connected in
• Has the input signal an appropriate level to
• Are you using effects in an appropriate level?
• Are the microphones connected to the XLR
• If you are using a condenser microphone, is
You can not hear the effects. • Make sure that the channels that you want to
• Also note if the effect fader is up.
You want the voices to be heard clearer. • Adjust the equalization parameters of each
If the problem continues, please contact the repair service.
current net through the voltage line provided
by the Factory?
sources correctly connected to the unit inputs
adjusted? Is the main output fader up? (MAIN
MIX)
adjusted? Is the main output fader up? (MAIN
MIX)
the Microphone XLR Input and line TRS of a
same channel? Please connect only one input
instrument per channel.
enter to the unit?
inputs?
the Phantom Power (+48V) on?
send to be processed by the effect have the
effect sending switch correctly set up.
channel.