Altec Lansing Mix Guia Del Usuario página 16

Setting eQ Controls
NoTe You can personalize the EQ presets by selecting a Preset EQ then
pressing the "EQ" button twice to enter the Bass/Treble Control Mode.
There you can make adjustments to the Preset EQs as described in the
Bass and Treble Control sections. Changes are saved automatically.
NoTe: To reset the EQ Presets to factory settings, press and hold the EQ
button for a few seconds.
How to Adjust the 7-Band Graphic eQ Using the onboard controls
For even greater personalization of your music, you can dial in your sound
with the onboard 7-band graphic EQ.
1
enter the Graphic eQ Mode.
Press and hold the "EQ" button while you press the
2
Select a frequency slider for adjustment.
Press the or buttons until the desired slider is highlighted.
3
Increase or decrease the level of the frequency slider.
Rotate the knob.
4
Select the next frequency slider for adjustment.
Press the or buttons until the next desired slider is highlighted.
5
Increase or decrease the level of the frequency slider.
Rotate the knob.
6
Continue selecting and adjusting frequency sliders as desired.
7
exit the Graphic eQ Mode.
Press the "EQ" button again. Or the unit will automatically exit this
mode after several seconds.
To reset the Graphic EQ to factory settings, press and hold the "EQ"
NoTe:
button for a few seconds.
14
How to Adjust the 7-Band Graphic eQ Using the clip-on remote
1
enter the Graphic eQ Mode.
On the speaker system, press and hold the "EQ" button while you
press the
2
Select a frequency slider to adjust.
Press the
is highlighted.
3
Increase or decrease the level of the frequency slider.
Press the + or "–" buttons on the clip-on remote.
4
Select the next frequency slider to adjust.
or buttons.
Press the
slider is highlighted.
5
Increase or decrease the level of the frequency slider.
Press the "+" or "–" buttons on the clip-on remote.
6
Continue selecting and adjusting frequency sliders as desired.
7
exit the Graphic eQ Mode.
Press the "EQ" button on either the clip-on remote or the speaker
system. Or the unit will automatically exit this mode after several
seconds.
NoTe: To reset the Graphic EQ to factory settings, press and hold the "EQ"
button for a few seconds.
or buttons.
or buttons on the clip-on remote until the desired slider
or buttons on the clip-on remote until the next desired