Trigano 28970 Instrucciones De Montaje página 21

123793 - GB
A - Stage 1, 2, 3, 4, 5, 6, 7:
Start by drilling all the planks (#2) using the Ø3 drill bit using the black plastic tip (#18) as a drilling
guide.
Then assemble your parts using the green plastic tips (#17) and paying attention to the assembly
dimensions that must be respected.
The vertical measurements are given at the bottom of the posts just above the plank.
B - Stage 8 & 9:
Drill the four planks (#3), in the same way as in stage 1, for the extremities.
Drill holes in the middle of the planks as shown in the stage diagram.
Install the two planks paying attention to the installation dimensions. (One of the two planks does
not have green tips and is to be assembled second)
C- Stage 10:
Install the three planks (#2) paying attention to the installation dimensions and slide the plank
(#25) so that it rests on these three planks.
D - Stage 12:
Support the plank (#25) from underneath with the reinforcement (#14) and attach it in line with the
vertical poles (#8).
Then drill the plank (#25) using a Ø7 drill bit where the two holes from part #14 can be found.
Then attach #14 to #25 using screws.
E - Stage 14, 15:
Drill planks #1, #4, and #6 as per the diagram in stage 14.
Then install the planks starting with plank #4 (as per the diagram for stage 15a) respecting the
spacing measurements giving on this diagram.
Then install the rungs (#13) respecting the spacing dimensions given in stage 15b.
F - Stage 16:
Drill the four planks (#5) as per the diagram for the stage (using the black plastic tip (#18)).
Correctly position the drilling template on the edge of the plank and drill the three holes.
Then install the lower plank (#6) of the upper section at 75mm in relation to the upper floor and
place the upper plank (#5) at 620mm (paying attention to the direction of the slat ends)
Screw in the metal sheeting (#11) on the two element (#5) that you have just installed.
Repeat this operation for the lower section of the tower except that the lower plank (#6) should be
at 670mm in relation to the bottom of the posts (#8).
Assemble parts #12 on the top of the posts (#8) without attaching them.
21 Notice N°123 793 Rev B