Operation - Muskoka 310-42-45 Manual Del Usuario

Operation

USING THE MANUAL AND REMOTE CONTROLS
On the top-right side plate of the electric fireplace (A) is the control panel. This panel contains the buttons to properly operate the electric
fireplace. The buttons on the control panel on the side of the electric fireplace (A) and the remote control (K) function in the same way. The
remote control has an effective range of up to 13 ft.
1. Power Button
2. Flame Control Button
3. Heater Control Button
4. Timer Control Button
5. Side Light Control Button
6. Heater on / off Switch
7. Ember Bed Control Button
8. Digital Display Panel
USING THE POWER BUTTON
□ The main power button (1) is located on the control panel on
the side of the electric fireplace.
□ Pressing the power button (1) once turns the power on.
□ Pressing the power button (1) again will turn the power off.
□ If you find that none of the other buttons appear to work,
check to make sure that the main power (1) is turned on.
USING THE FLAME CONTROL BUTTON
□ Press the flame control button (2) to turn on the ember
bed and flame effect.
□ Pressing the flame control button (2) once turns
flames on and lights the ember bed.
□ Pressing the flame control button (2) again will cycle
through different colors of the ember bed. The color
rotation mode will cycle through different color
settings continuously. Reference the table for more
detailed information.
5
7
2
K
BATTERY REPLACEMENT
3 Volt lithium coin cell type CR 2025
This product contains a button battery. If swallowed, it could cause severe injury
or death in just 2 hours. Seek medical attention immediately.
Button Press Display Value Ember Bed Color
1st Press
2nd Press
3rd Press
4th Press
5th Press
6th Press
7th Press
1
3
6
4
1 Orange
2 Green
3 Blue
4 Orange/Green
5 Orange/Blue
6 Orange/Green/Blue
7 Cycle
8
4
5
3
7
2
1
1 1