Operation
ATTENTION
Risk of damage! If the suction decreases,
immediately turn off the motor.
Turning on the Appliance
Switch on the appliance at the main
switch.
Eco mode
Eco mode (energy saver mode): The appli-
ance works with reduced suction perfor-
mance. The battery life will extend.
To switch on eco mode: Press the eco
button.
To switch off eco mode: Press the eco
button again.
Cleaning operations
Note: The battery life will shorten because
of increased cleaning performance while
cleaning textile covering.
Set the selection switch of the floor noz-
zle to hard surface or carpet.
Regulate the suction force on the suc-
tion force regulator (continuous).
Perform the cleaning operation.
Turn off the appliance
Switch off the appliance at the main
switch.
After each operation
Empty main filter basket if necessary.
Use a moist cloth to clean the appliance
and the accessories after use.
Transport
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Press the unlocking key and remove
the battery to avoid discharge.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
DANGER
Turn the appliance off and remove the bat-
tery before carrying out any tasks on the
machine.
Replace the fleece filter bag or
paper filter bag (option)
Illustration
Release and remove the filter cover.
Remove the fleece filter bag or paper fil-
ter bag (option).
Illustration
Pull a new fleece filter bag or paper filter
bag (option) with rubber flange over the
suction support (interior).
Insert and lock the filter cover.
Clean main filter basket
Main filter basket (washable), clean it
under running water if necessary.
ATTENTION
Risk of damage! Never insert the main filter
basket while wet.
Replace exhaust filter
Exhaust filter: Change once a year
Remove cover.
Unlock the filter housing and remove it.
Remove the exhaust filter from the filter
housing.
Insert new exhaust filter into filter hous-
ing.
Insert and click the filter housing into its
place.
Replace cover.
– 4
EN
Storage
9