Sealed Star™ Burners; Burner "On" Light - Thermador SGS Manual De Uso Y Cuidado

Sealed STAR™ Burners

Burner "ON" Light

English 4
Figure 3 - Model SGS456/SGSX456
1
1. Left front surface burner (8,000 BTUs) - XLO feature on SGSX model only
2. Left rear surface burner (12,000 BTUs) - XLO feature on SGSX model only
3. Right rear surface burner (8,000 BTUs)
4. Right front surface burner (12,000 BTUs)
5. Center left surface burner (15,000 BTUs)
6. Center right surface burner (15,000 BTUs)
7. Burner "On" Indicator Light
8. Serial Number/Data Plate Location (right front underneath)
Your new cooktop has sealed STAR™ gas burners. There are no burner parts
under the cooktop to clean, disassemble or adjust. Your cooktop has three differ-
ent burner sizes; small, medium and large. Match the pan to the size burner-
STAR™ Burner Caps.
The burner cap is porcelainized steel. If the burner cap is not placed correctly, the
burner may not light or the flame may not burn completely or correctly.
Figure 4 - Burners Caps
WARNING:
cooktop without all burner caps and all burner grates properly posi-
tioned.
The "ON" light is located in the center of the burner control knobs for the 30"
(76cm) and 45" (114cm) models. On the 36" (91cm) model it is to the left of the
control knobs. When illuminated, it indicates that one or more burners are in use.
It remains on until all burners are turned off.
2 5 6
1 2 5 7 6 3
To avoid creation of harmful by products, do not use the
3
4 4 8