Electrical Installation - Gabarron GTC-30 Instrucciones De Instalacion Y Uso

ELECTRICAL INSTALLATION

Never connect the immersion heater if it is not filled with water.The
appliances are powered at single-phase 230 V~.Carefully check that the
supply voltage matches the appliance voltage.The immersion heater does
not require any special installation and it is therefore just needs to comply
with the Low Voltage Electro-technical Regulations.Even though it is clearly
known by the installers, we have set out some basic rulesbelow:
"For installations in bathrooms or toilets, the following volumes and
indications for each of them will be taken into account".
PROHIBITED VOLUME. - It is the volume limited by the tangential and
vertical planes with respect to the outer edges of bathtub, toilet or shower,
and the horizontal planes consisting of the floor and by a plane situated 2.25
metres above those units or the floor, should the units be embedded in the
floor.
PROTECTION VOLUME. - It is the volume situated within the horizontal
planes stated for the prohibited volume plus other vertical ones 1.20 metres
away from those of that volume.
No switches, power sockets or lighting equipment may be installed within the
PROHIBITED volume.
Do not install switches with the PROTECTION volume, but this does not
apply to safety power sockets or ones protected by <s 30mA RCD.
The heater must be installed outside the PROHIBITED VOLUME so as to
prevent water splashing against the unit.
Power must be supplied through an earthed connection.The plug used by
the storage immersion heater is already fitted with this connection and only
has to be inserted in a mains socket with the same feature.
Make sure that the electrical installation of the premises or house is earthed.
This appliance complies with the regulations regarding radio-electrical
disturbances and interferences.
N.B.:Any handling and replacement of pieces (including the power
cable) is strictly forbidden unless carried out by the Technical
Assistance Service.