Maintenance & Care - Bissell REVOLUTION PET PRO 1986 Serie Guía De Inicio Rápido/Del Usuario

Empty Dirty Water Tank
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To release dirty water
tank, press down on the
colored tank handle.
4
16
www.BISSELL.com
2
Tilt the tank slightly
toward you.
For quick empty:
Pull the rubber tab
and tilt to pour.
(Located at the corner
of the top of the tank.)
When closing the
rubber tab, make
sure all edges are
sealed tight.
For final clean and
rinse: Unscrew the ring
at the bottom of tank.
Gently remove the
float stack, rinse,
and clean.
Once clean, return float
stack into the tank by
lining up the arrows
so they point at each
other. This is the only
way the float stack will
fit into the tank.
With the arrows
aligned, the float stack
should lock into place.
Return the ring and
twist to lock. Water
may leak if the ring is
not fully tightened.
3
Grab the handle and tank
with both hands and pull
the dirty water tank up
and away to remove.
5
Clean the red filter
below the dirty
tank by wiping off
any remaining dirt
or debris.
6
To return the dirty
tank: Angle the tank
and insert bottom
first. Then tilt the
tank toward the
machine and push
the top in until it
clicks into place.
Did You Know?
The Float Stack
is what prevents
your dirty
tank from
overflowing.