Cosatto Nitty Gritty Supa Dupa Manual Del Usuario página 5

Pass the harness straps through the slots in the footmuff and seat liner (b, c & d).
Attach the fastener straps (e) at the top of the footmuff to the back of the seat.
Slide the headhugger and chest pads back onto the shoulder straps and re-fasten the buckle.
8 - using the backrest
The backrest can be adjusted in four different positions. To lower the backrest, simply lift the
lever behind the backrest. The backrest will drop down automatically. To raise, push the
backrest upwards from the centre to the required angle: it will lock into place automatically.
9 - using the calf supports
To lower, push the buttons on both sides of each seat whilst simultaneously pushing the calf
support downward.
To raise, just pull the calf support upward and it will automatically lock into place.
10 - removing the baskets
Your baskets are removable for easier cleaning. To remove a basket, undo the four straps, two
either side. To re-fit the basket, simply reverse the above process. Maximum load 2kg of goods,
evenly distributed in each basket.
11 - fitting the hoods
Fit the hoods around the centre handle (a). Place the back behind the seat (b) and clip the brackets
into the mountings on the chassis tubes (c) and push down until they lock in place.
Attach the fastener tabs to the seat on each side (d). Fastener tabs at the bottom of the hood
attach to the back of the seat when the backrest is in its lowest position.
Attach the fastener loops on the outside edge of each hood to the front leg tubing (e).
To remove the hood release all the fastener tabs and loops. Press the levers under the hood
mountings (f) then lift the hood clear. The levers on the outer edges can be accessed from the
outside of the pushchair. Pull the seat fabric back to gain access to the centre lever.
12 - using the hoods
To raise the hood, pull the top of the hood forward (a) until it locks in position.
To lower the hood, simply push the hood back (b).
To extend the hood, unfasten the zip (c) around the rear frame of the hood then pull the front of
the hood forward (d). To close the extension, push the front of the hood back and refasten the zip.
13 - using the multimedia pockets
A speaker is fitted at the rear hood pocket for connecting to media player.
The flap covering the rear pocket can be raised (a) to reveal the pocket in the back of the hood.
Place the speaker, facing towards the seat, into the inner pocket (b). Holes in the speaker identify
the front face (c). Feed the jack plug through the hole in the inner pocket (d). Connect the jack
plug to your media player (not supplied) and place your media player in the rear pocket.
Note: The speaker is intended to be used only when fitted correctly in the inner pocket.
Note: Only use the speaker supplied or an official Cosatto replacement.
A pocket for a tablet computer is located in the front section of each hood.
To fit your tablet computer (not supplied) pull back the flap (e) and carefully slide the tablet into
position (f). Once in place fold the flap back to cover the open end of pocket.
Note: Please ensure the open end of the pocket is covered at all time even if pocket is not in use.
Note: Your tablet computer must be no more than 250mm x 190mm x 10mm in size and weigh
no more than 700g.
Remove your tablet computer before folding back the hood or closing the pushchair.
WARNING: See the "safe use of electronic goods" section at the beginning
of the document regarding the safe use of the speaker and tablet computers.