Using The Remote Control; Remote Control Keys (Functions) - Sanyo HT27546 Manual De Instrucciones

PRECAUTIONS
To ensure safe operation, please observe the following precautions:
Replace both batteries at the same time. Do not use a new battery with
a used battery.
Risk of explosion, if battery is replaced by an incorrect type.
Do not expose the Remote Control Unit to moisture or heat.
REMOTE CONTROL KEYS
Œ
Input Key—Press to change the input signal source
as follows: Analog RF ¬ Digital RF ¬ Video1 ¬ Video2
¬Component2 ¬ Analog RF .

Number Keys—Two keys must be pressed to select
a direct channel. Example: Press 0 then 6 to select
channel 6.
For Analog Cable channels above 100, press and
hold the 1 key until C1– – appears, then press the
other two numbers.
Ž
Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display).
Digital Full Banner display —Contains a two-part
Channel Number (Major and Minor) and Tuner ID. If
available the following is also included: Audio Info,
Program Title, and V-Chip Program Rating.
Program Rating
Analog Full Banner display —Contains the Channel
Number (analog antenna/cable), Tuner ID, Station ID (if
available), Program Title (if available), and V-Chip
Program Rating.
Program Title
Program Rating
12
Need help?
Visit our Web site at

USING THE REMOTE CONTROL

Digital Channel
Tuner ID
Major
Program Title
Audio Info
Cable Channel
Station ID
www.sanyoctv.com
Œ

Ž


‘
’
“
Minor
”
•
1-800-877-5032
or Call
Points toward
TV
11
12
13
14
15
16
17
18