Kramp GOPART FGP455239GP Manual Del Usuario página 6

STEP 1: INSTALLING THE WHEELS
1. On the left side of axle install a wheel bushing and wheel spacer into the axle.
2. Slide a wheel over the axle.
3. Put an Ø16 flat washer over the axle, insert the cotter pin through the hole
and secure by bending.
4. On the right side of the axle slide a wheel bushing and the wheel spacer into
UK
the axle.
5. Put a wheel over the axle, line up the holes and insert the drive pin through
sleeve and lock.
6. Put an Ø16 flat washer over the axle, insert the cotter pin through the hole
and secure by bending.
NOTE: Four additional flat washers are provided for adjusting the gap between the wheels.
Slide the Wheel Bush-
ing and Wheel into the
Axle
Cotter Pin Ø5X35
6
Slide the Wheel Bushing and Wheel into
the Axle and align the two holes then
insert the Drive Pin.
Here are 4 pcs of Flat Washers Ø16
used for adjusting the gap between
the wheels.
Flat Washer Ø16
Cotter Pin Ø5X35
Flat Washer Ø16