Troubleshooting; Safety Warnings - Astralpool LumiPlus RGB-DMX Guia De Inicio Rapido

3. TROUBLESHOOTING

Problems
The display that indicates the DMX
address does not turn on
The green LED in the DMX modulator
does not light up
The projectors change colour or go out
for a few moments
If you are unable to solve the problem with these instructions, contact the technical department of AstralPool.

4. SAFETY WARNINGS

• The persons who are in charge of assembly should have the required qualifications for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed. WIRING IN BUILDINGS. SPECIAL WIRING. SWIMMING
POOLS.
• Any operation related to the maintenance or replacement of parts should be performed with the floodlamp disconnected
from the electric power system.
• The lamp is designed TO BE USED ONLY SUBMERGED IN WATER and TO OPERATE ONLY WITH A SAFETY TRANS-
FORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
Usual causes
Current is not reaching the equipment
Defective DMX signal
Faulty power supply in the projectors
or in the DMX modulator
4
Solutions
Check the mains socket (230V~AC)
and the 12 V~ac power line
Check the installation of the DMX
line. Only the line termination of the
last DMX equipment of the DMX com-
munications bus should be activated
Check the 12V~AC power supply line
of the projectors and the DMX modu-
lator