Hold; Conference Calls - RCA 25210 Manual De Instrucciones

Ringer On/Off and Ringer Volume
1. Make sure the phone is in idle mode.
2. Press the VOL (+ or -) button to activate the ringer Volume setting. Use
the VOL (+ or -) button to scroll to your selection and use the DIR or
CID button to toggle between L 1 and L 2. The default setting is VOL 3.
3. Press the SELECT soft key to save your selection.
NOTE: If you choose the ringer OFF, the screen displays "L1/L2 RINGER OFF".
Speakerphone, Handset, and Headset Volume
While the phone is in use, during the desired mode, press the VOL (+ or -)
buttons until you reach a comfortable listening level. The phone stores the
setting after the last button pressed.

Hold

In Talk mode, press the Hold button to hold the line. The screen displays
"Line X ON HOLD", and the line icon will flash. On the base, the Line button
indicator will flash also.
When the line is on hold, the hold alert tone will be emitted.
Press the corresponding LINE soft key (on handset), or the Line button (on
base) to release the hold and pick up the call again.

Conference Calls

This system can support 3-way and 4-way conference calls.
Join a call in progress:
1. While a call is in progress, another user can join that call by
pressing the corresponding Line button on the base unit or soft key in
the handset. Both parties on the original call will hear a tone to alert
them someone else has joined the call.
NOTE: If the privacy feature is On for the original call, the call cannot be
joined by another user.
Three-way conference call by an intercom call:
1. While on a call, press the Intercom button and then select the desired
handset or base to intercom.
2. The selected handset or base will emit a page tone. The user can press
the Talk button on the handset or the Speaker button on the base to
answer the intercom call page.
3. The originating caller can then press the CONF soft key displayed on the
screen to establish a 3-way conference between the external caller and
the intercom call.
Three-way conference call with two lines:
1. During a call on Line 1, press the Hold button to put the call on hold.
2. Press the Line 2 button or soft key on the handset to get a dial tone.
Dial the number, and then talk to the other person.
3. The originating caller can then press the CONF soft key displayed on the
screen to establish a 3-way conference between the two lines.
Telephone Operation
25