Johnson Controls VARTA VSSP 2.0 Manual De Instrucciones página 96

Operation
NOTE
Erasing fault codes
34 VSSP 2.0
A table of fault messages from the control units of the
vehicle is displayed.
Fault Code
B1605
B1606
B1607
B1627
B1628
If you would like to view fault correction information, tap
on the appropriate error message.
Before you can replace the used up battery with a new
battery, you must erase the fault codes in the control
units of the vehicle. To do this proceed as follows:
Tap on the Next button.
The message, Please connect the OBD plug is
displayed.
Connect the VSSP 2.0 to the vehicle via the OBD cable.
Tap on the Next button.
In the screen Corrective actions the message Turn on
engine... is displayed.
Start the vehicle's engine.
The message Turn off engine... is displayed.
Switch off the vehicle's engine again.
The message Key on... is displayed.
Switch on the vehicle's ignition.
Tap on the Next button.
Description
Fault in the re-initialisation...
Battery charge status unit ...
Fault in the memory of the...
Battery current sensor fault...
Battery voltage sensor fault ...
75% de 15:16