How To Prepare The Machine For Operation - Clarke American Sanders 07127A Manual Del Operador

HOW TO PREPARE THE MACHINE FOR OPERATION

How to Install the Sandpaper
NOTE: Use a sandpaper disc that has a 7" diameter and a
/ hole in the center.
7
8
1. Put the machine upside down.
2. A special wrench is in the bracket behind the mo-
tor. Use the special wrench to remove the screw
and washer from the center of the sanding pad. See
Figure 3.
3. Put the sanding disc in position on the sanding pad.
4. Put the special washer and the holding screw in posi-
tion in the center of the sanding pad.
5. Put one hand on the sandpaper. Using the special
wrench, turn the screw clockwise with the other hand.
Make sure the screw is tight. See Figure 4.
6. Return machine to upright position.
WARNING: Serious injury could occur when attempting
to replace abrasive while machine is con-
nected to power supply. Always disconnect
power before installing abrasive.
CAUTION: Gearbox damage could result from ma-
chine resting upside down for extended
periods of time. Lubricant may drain from
gearbox. Always return machine to upright
position after installing abrasive.
American Sanders Operator's Manual (EN) - American B2
Clarke ®
ENGLISH
Figure 3
Figure 4
FORM NO. 70896A - 7 -
EN