peerless-AV SS560M Manual De Instalación página 12

For Flat Back Display
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as
14-1
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
14-2
display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
ADAPTER
BRACKET (F)
DISPLAY
SPACER
12 of 41
fi g. 14.1
MULTI-WASHER
SCREW
fi g. 14.2
MULTI-WASHER
SCREW
ADAPTER
BRACKET (F)
ISSUED: 02-25-11 SHEET #: 009-9052-2 10-30-11