Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Suitable for induction cooking
32
Operation
4.10 Switching the appliance into the standby mode
This regulator is used to switch the entire hob operational. It
is, as it were, the main switch. An automatic test of the cont-
rols will be carried out fi rst of all, and the displays will light up
briefl y.
When the hob has been switched off with this control knob, it
will remain on standby for approx. another 120 min.
Attention! The residual heat indicator will no longer operate
when the appliance has completely switched off .
4.11 Switching on the hob and cooking zones
1. Turn the control knobs to the right.
The power setting display shows:
1 2 3 4 5 7 8 9
2. Immediately put cookware suitable for induction cooking
onto the cooking zone. The pan recognition device will ac-
tivate the induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone,
the display will alternate between the power level set and
the symbol
. If no pot is placed on the cooking zone it will
switch off after 10 minutes for reasons of safety. Please
refer to the Section on pan recognition.
4.12 Switching off a cooking zone
3. Turn the regulator to the left to 0.
4.13 Childproof lock
The childproof lock serves the purpose of preventing children
from switching on the induction hob either accidentally or
intentionally. The controls are blocked here.
Switching on the childproof lock
1. Turn the regulators of the front and back cooking zones
simultaneously to the left until they stop and a signal
sounds.
The power setting indicators will show an
the controls will be disabled and the hob will switch off .
Switching off the childproof lock
2. Turn the regulators of the front and back cooking zones
simultaneously to the left until they stop and a signal
sounds. The
will go off .
Notes
•
In the event of a power cut the childproof lock will be can-
celled, i.e. deactivated.
GB
for child lock,
Publicidad
Capítulos
Tabla de contenido
