Electrical Connection - KÜPPERBUSCH KMI9850.0 Manual De Instrucciones

Rear view
Cupboard cover
Rear view
25
-0,1
Blind hole for screw

7.12 Electrical connection

WARNING OF ELECTRICAL ENERGY!
RISK OF FATAL INJURY!
Live components have been installed near this
symbol. Covers bearing this sign may only be
removed by a certifi ed skilled electrician.
• The electrical connection must be carried out by a
qualifi ed electrician who is authorised to carry out such
work!
• Statutory regulations and the connection specifi cations
issued by the local power supply company must be
strictly observed.
• When connecting the appliance it must be ensured that
there is a device which makes it possible to universally
disconnect it from the mains with a contact opening
width of at least 3mm. Line-protecting switches, fuses
or contactors are suitable cut-out devices. When
connecting and repairing the appliance disconnect it
from the electricity supply with one of these devices.
44
Instructions for assembly
290
±0,05
190
±0,05
220
±0,05
Nut
Washer
Stud bolt
Lengthening spindle
Screw
Guide Sleeve
5 4 3 2 1
290
±0,05
190
±0,05
220 220
±0,05
Pass hole for sleeve
• The earth wire must be suffi ciently long so that if the
strain relief fails, the live wires of the connecting cable
are subjected to tension before the earth wire.
• Any superfl uous cable must be removed from the ins-
tallation area beneath the appliance.
• Make sure that the local mains voltage is the same as
the voltage on the rating label.
• Full protection against accidental contact must be en-
sured on installation.
• Attention: Incorrect connection may result in the power
electronics unit being destroyed.
• The appliance is only authorised for permanent
connection. It may not be connected with a shock-proof
plug.
Power supply
Mains voltage: 380-415V 3N~, 50/60Hz
Component rated voltage: 220-240V
Retaining plate
Cupboard cover
Sleeve
±0,05
GB
Regulators
Stud bolt