Adjusting The Handlebar; Use With Infants Under 6 Months; Adjusting The Footrest; Using The Seat Belt - JANE CROSSWALK Manual Del Usuario

I. ADJUSTING THE HANDLEBAR
The handlebar can be set to 7 different positions. Simultaneously
press the buttons on both sides of the handlebar.
J. SEAT BELT
Your pushchair has a safety harness to keep your child safe at all ti-
mes. Fit the belt onto the child whenever he is using the pushchair.
15.1 To open the belts, press the button in the middle of the harness.
15.2-15.3 To fasten it, bring the two side straps together and then
insert them into the harness until they click into place.
15.4 Adjust the belts so that they fit the child correctly with the right
tension. To adjust the length of the belts, slide the buckles up or
down. Make sure that the belts are not twisted.
K. USE WITH INFANTS UNDER 6 MONTHS
To use the seat with children under 6 months old, adjust the angle
of the seat to the most reclined position.
Adjust the harness to the lowest position.
IM 1683.02 CROSSWALK 27-10-16 adv.indd 29
L. ADJUSTING THE FOOTREST
The footrest can be adjusted to 5 different positions. Use your
14 thumb to simultaneously press the two buttons on the lower part of
the hammock.
M. USING THE PARKING BRAKE
15
PUTTING THE BRAKE ON: Push the operating lever on the right of
the handlebar down to activate the parking brake of your stroller.
17
TAKING THE BRAKE OFF: Press the release button and move the ope-
rating lever on the right of the handle bar upward to release the
parking brake..
To adjust the brake:
If you need a more precise adjustment follow the indications in figu-
re..
!
10
.a
15
.a
16
17
.a
18
WARNING: When the brake is on make sure that the pushchair
has braked correctly. It may be necessary to push the pushchair
slightly for the brake to be fully activated.
EN 29
27/10/16 11:29