Assembly; Operations; Opening The Trolley - Workzone AET14 Manual Del Usuario

Assembly

Install the castors before using the trolley (see fig. B).
1. Place the trolley upside down.
2. Place the fixed castors
rear end of the trolley. Line up the holes on the castors with those on the
trolley.
3. Insert the screws
8
nuts to the screws.
4. Tighten all screws with the wrench

Operations

CAUTION!
Risk of crushing!
You could crush your fingers when setting up the trolley.
− Be very careful when you are opening or closing the
trolley.
NOTICE!
Risk of damage!
If you do not use the trolley properly, you could damage it.
− Pull the handle far enough so that it locks into the end
position before use. If not locked, the handle may retract
when the trolley is pushed forward.

Opening the trolley

To open the trolley:
1. Pull the rear guard
step 1 in fig. C).
2. Press the rear guard downward and pull the handle upward until it latches
(see step 2 in fig. C).
The trolley is now ready for use.
6
at the front end and the swivel castors
7
through the holes from below and then attach the
2
and handle
9
.
1
assembly upward until it locks (see
Operations
4
at the
11