Twin-Star International 28MM6240 Manual De Instrucciones Adjunto página 7

6. Locate the upper side panels (E,F) and center
shelf and set out face down on a scratch-free
surface. Insert one wood dowel (CC) into each of
the pre-drilled holes.
Locate the Upper side panels (E, F) on the center
shelf as shown in diagram. Make sure that dowels
are seated into the pre-drilled holes. Using Bolts
(AA) and washers (BB) attach these panels through
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
7. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 6. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly.
From the inside, attach the Mantel/Top (G) using
Bolts (AA) and Washers (BB) through the pre-drilled
holes in the mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
8. Rest Back Panel (J) into groove on Mantel Top (G)
back edge. Allow the pre-installed magnets to keep
the Back Panel (J) in closed position.
Fig. 6
E
x 4
x 4
x 4
Fig. 7
x 4
x 4
x 4
Fig. 8
6
AA
BB
CC
G
CC
BB
AA
J
F