Sammic LU-60 Instrucciones página 9

following for hygiene's sake:
- Fill the machine with water (without detergent).
- Perform several wash cycles on no load.
- Drain the machine completely.
Repeat the above steps, until water flows out
clear, without any residue or detergent.
· At least once a week, sterilise the machine
with appropriate disinfectant products. After
this operation, perform several rinsing cycles,
each of a duration of several minutes (fill up
the tub with the overflow removed).
OTHER IMPORTANT REMARKS
· Never move the appliance from its original
location.
· Before cleaning, servicing or repairing the
machine, it is necessary to unplug it from the
mains.
· When the appliance is going to be inactive
for a long period of time or at night, the door
should be kept open for aeration and avoiding
nasty smell.
· In case of a drain pump failure:
1.Drain the wash tank into a container until the
water level drops below the overflow.
2.With the overflow in place, remove the front
bottom panel and change the pump (this can
be done without moving the machine). In order
to drain the dishwasher manually, connect a
drain hose to the collector. On pulling out the
overflow, water flows out of the tank by gravity.
· In the event the power supply cable should get
damaged and have to be replaced, the repair
may only be done by a SAMMIC approved
assistance service .
· Airborne noise: the emission noise level
measured on a typical machine is 76 dB(A) at
a distance of 1m.
TABLE
Config No. Drain Pump
No
1
No
2
5 Yes
6 Yes
Thermal Hang-up
No
Yes
No
Yes
Diswasher model
Without drain pump. Without thermal hang-up
Without drain pump. With thermal hang-up
With drain pump. Without thermal hang-up
With drain pump. With thermal hang-up
EN
9