2.7
The Air Cooling Controller (BAC-AF-PB-0032) allows the operator to adjust
the temperature of the incoming air supply to the Supplied Air Respirator
Helmet. This is done by rotating the adjusting knob until the desired air
temperature is achieved.
2.8
It is normal for warm air to be discharged from the vent hole in the bottom
of the Air Cooling Controller while in operation.
2.9
It is recommended that the Air Cooling Controller be used when the
incoming air supply to the Supplied Air Respirator Helmet becomes too
warm for the operator to work comfortably.
AIR FLOW INDICATOR RED
FOR INADEQUATE AIR FLOW
- 4 -
COOLING
LEVEL KNOB