Important Safety Instructions; Personal Precautions - MAC TOOLS MTPROA Manual De Operación Y Mantenimiento

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS.
RISK OF ELECTRIC SHOCK OR FIRE.
•
• Read the entire manual before using this product. Failure to do so could result in serious injury or death.
• This product is intended for 12V electrical systems. Connecting to a system with higher or lower voltage could cause injury to
the user and damage to the product/systems.
• This jump starter is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the jump
starter by a person responsible for their safety.
• Children should be supervised, to ensure they do not play with the jump starter.
• Do not put fingers or hands into the jump starter clamps.
• Do not expose the jump starter to rain or snow.
• Do not operate the jump starter with damaged cables or clamps; have the cable or clamp replaced immediately by a qualified service
person.
• Do not operate the jump starter if it has received a sharp blow, been dropped or otherwise damaged in any way; take it to a
qualified service person.
• Do not disassemble the jump starter; take it to a qualified service person when service or repair is required. Incorrect
reassembly may result in a risk of fire or electric shock.
RISK OF EXPLOSIVE GASES. WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS
•
DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY
OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE
INSTRUCTIONS EACH TIME YOU USE THE JUMP STARTER.
• To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the manufacturer
of any equipment you intend to use in the vicinity of the battery. Review the cautionary markings on these products and on the engine.
• This jump starter employs parts, such as circuit breakers, that tend to produce arcs and sparks. If used in a repair facility,
locate this jump starter 18 inches (46 cm) or more above floor level.

PERSONAL PRECAUTIONS

A spark near the battery may cause a battery explosion. To reduce the risk of a spark near the battery:
•
Work in a well-ventilated area.
•
NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
•
Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead-acid battery.
•
A lead-acid battery can produce a short-circuit current high enough to weld a ring or the like to metal, causing a severe burn.
Be extra cautious, to reduce the risk of dropping a metal tool onto the battery. It might spark or short-circuit the battery or
•
other electrical part that may cause an explosion.
Never jump start a frozen battery.
•
To prevent sparking, NEVER allow clamps to touch together or contact the same piece of metal.
•
WARNING! RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS A HIGHLY
CORROSIVE SULFURIC ACID.
Consider having someone nearby to come to your aid when you work near a lead-acid battery.
•
Have plenty of fresh water and soap nearby in case battery acid contacts your skin, clothing or eyes.
•
Wear complete eye and body protection, including safety goggles, gloves and protective clothing. Avoid touching your eyes
•
while working near the battery.
If battery acid contacts your skin or clothing, immediately wash the area with soap and water. If acid enters your eye,
•
immediately flood the eye with cold running water for at least 10 minutes and get medical attention right away.
If battery acid is accidentally swallowed, contact poison control and reference MSDS. Seek medical attention immediately.
•
Keep the jump starter in the specified temperature range: operation: -10°C (14°F) to 40°C (104°F); charging: 0°C (32°F) to
•
40°C (104°F); storage : -15°C (5°F) to 40°C (104°F).
800.MACTOOLS
WARNING
3