Kinderkraft KOYA Manual De Usuario página 34

•
Information on the types of adult bed for which the bedside sleeper is suitable can be
found on picture K.
•
User shall not use other attachment system.
•
Bedside sleepers shall never be used in an inclined position
•
To prevent a suffocation hazard from entrapment, the bedside sleeper shall be
properly secured to the adult bed using the attachment system.
•
There shall never be a gap between the lower side of the bedside sleeper and the
mattress of the adult bed.
•
Check the tightness of the attachment system before each use by pulling the bedside
sleeper in a direction away from adult bed.
•
If there is any gap between the bedside sleeper and the adult bed, DO NOT use
product.
•
Gaps should not be filled with pillows, blankets or other items.
•
DANGER! – Always completely raise the drop side when not attached to the adult's
bed.
•
To avoid hazards from the child's neck being caught on the top rail on the side
that is next to the adult bed, the top rail must not be higher than the adult bed
mattress.
•
To avoid the risk of your child being strangled the attachment system to the adult's
bed shall always be kept away from and out of the crib.
•
Baby cot should have size 90 x 60 cm. Length and width shall be that there shall be no
gap more than 30 mm between the mattress and the sides and ends.
Baby cot 120 x 60 cm
•
Be aware of the risk of open fire and other sources of strong heat, such as electric
bar fires, gas fires, etc. in the near vicinity of the cot;
•
Do not use the cot if any part is broken, torn or missing and use only spare parts
approved by the manufacturer; spare parts may be only delivered by manufacturer.
•
Do not leave anything in the cot or place the cot close to another product, which
could provide a foothold or present a danger of suffocation or strangulation, e.g.
strings, blind/curtain cords.
•
Do not use more than one mattress in the cot.
•
The lowest position of the base is the safest (R-IV). When a child starts to sit down
without the assistance – use only this level.
•
Thickness of the mattress shall be such that the internal height (measured from the
top of mattress to the upper edge of the cot frame) was at least 500 mm in the lowest
position of the cot base and at least 200 mm in the highest position of the cot base.
•
Maximum thickness of the mattress: 6 cm.
34