Perry TE526 Manual Del Usuario página 26

3 - INSTALLATION
3.5 - PROCEDURE TO FASTEN OR REMOVE THE THERMOSTAT TO/FROM THE WALL-MOUNTED BASE
Attach the cable cover by inserting tooth
base, then fasten it to the hooks by pressing it lightly.
Use a small screwdriver to lever each hook so as to remove the cover.
EN
I
H
wall-mounted base
3°
In order to remove the
thermostat from the
wall-mounted base,
hold it as shown in the
diagram, then pull out-
wards by turning it to the
right.
26
G into the relative slot H
I
I
1°
G
of the
Fasten the thermostat onto the wall-mounted base
ensuring to insert the contacts correctly, then press
lightly until you hear the fastening teeth click into
place onto the base.
2°
Easy Programming
All the settings can be made before securing
the thermostat to the wall-mounted base.
This allows you to sit comfortably while
programming the settings.
Caution!
If the thermostat is programmed before being fastened to the wall-
mounted base, once installation is completed, the
display (off or blinking) may not correspond to the actual state of the
relay. Within 1 minute (max) after having fastened the thermostat to
the wall-mounted base, the relay will be activated in accordance with
ON
the indication displayed (off or blinking).
ON indicator on the