Fanimation The Benito Manual Del Propietário página 10

How to Assemble the Blades and Light Kit (continued)
4. Connect the 2-pin connector from the socket
plate assembly to 2-pin connector from motor
assembly (Figure 4).
5. Remove one of the three screws in the plate
assembly. Slightly loosen the remaining two
screws. Assemble the socket plate to the
adapter plate assembly using the two key slots.
Replace the third screw and securely tighten all
three screws (Figure 5).
6. Insert light bulbs into sockets (Figure 6 A).
6A. Don't install the light bulbs if you want to install
the lower steel cap in Step 7A (Figure 6 B).
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.
7. Assemble the opal frosted glass to the adapter
plate assembly by twisting in a clockwise direction.
Do not over-tighten (Figure 7 A)
7A. Assemble the lower steel cap to the adapter plate
assembly by twisting in a clockwise direction.
(Figure 7 B).
SCREWS (3)
LIGHT SOCKET
100-WATT
MINICAN LIHGT BULB (1)
Figure 6A
OPAL
FROSTED
GLASS
Figure 7A
10
MOTOR ASSEMBLY
2-PIN CONNECTOR
SOCKET PLATE 2-PIN
CONNECTOR
SOCKET PLATE
ASSEMBLY
Figure 4
HOUSING LIGHT
KIT ASSEMBLY
SOCKET PLATE
Figure 5
LIGHT SOCKET
Figure 6B
LOWER STELL
CAP ASSEMBLY
Figure 7B