Inglesina Zippy Manual De Instrucciones página 40

MAINTENANCE OF THE INTERNAL LINING
fig. 32 It is recommended to remove the internal lining
ADJUSTMENT OF THE BACKREST
fig. 33 To lift the backrest (C5) just pull it upwards.
fig. 34 To lower it, act on the lever (C6) positioned under
HUGGY CAR SEAT
HOOKING OF THE SEAT TO THE FRAME
ceed as follows:
fig. 35 Remove the armrest covers (P4
pressing with the index finger the hooking lever (P24) posi-
tioned inside the armrest.
fig. 36
frame on the armrests (P25
mum.
CAUTION: make sure that the seat is always properly hoo-
ked before use.
UNHOOKING OF THE CAR SEAT FROM THE FRAME
fig. 37 Act on the lever (S1) positioned on the rear side of
the seat.
fig. 38
handle.
manual.
HOOKING OF THE BACKREST TO COVERT THE FRAME
INTO A STROLLER
fig. 39 It is possible to hook to the frame the backrest
equipped with padding (P8) to obtain the stroller configura-
tion.
fig. 40 Insert the buckle (P26) in the proper buttonhole
positioned on the rear side of the seat support.
fig. 41 Insert the 2 ends (P27) on the pins (P28) on both
sides of the frame.
fig. 42 Hook the ends (P27) until hearing a CLICK confir-
ming the hooking. Make sure that perfect hooking occurred
on both sides. In case of need, to unhook the ends (P27),
press the element (P29
fig. 43 Insert the backrest adjusting levers (P30) in the
proper seats (P31) on both sides of the frame until hearing a
CLICK confirming the hooking.
fig. 44 Make sure that perfect hooking occurred on both
sides. In case of need, to unhook the levers (P31) press the
push-button (P32
fig. 45 Insert the buckle of the crotch strap (P33) in the
proper buttonhole on the front side of the seat support.
fig. 46 Insert the levers (P34) of the footrest in the proper
openings on the covering.
fig. 47 Fasten the armrest covers (P4) to the covering as
shown in figure.
fig. 48 Then, hook the armrest cover (P4) to its proper seat
fig. 49 Hook the buttons (P35) of the covering to the Strol-
ler seat.
fig. 50 The armrest cover (P4) can be removed to allow
Stroller version. With the index finger press the hooking le-
ver (P24) positioned inside the armrest. To re-assemble it,
insert the front part in the opening on the armrest and press
downwards.
40
INSTRUCTIONS
ADJUSTMENT OF THE BACKREST
fig. 51
act on the central device (P36) and bring the backrest to the
wished position.
USE OF THE HANDRAIL
fig. 52
ends in the openings on the armrests (P25) and then press
fig. 53
under the armrest. To remove it, repeat the procedure also on
- the other side.
CAUTION: do not insert the fingers in the openings on the
armrests when performing these procedures.
ADJUSTMENT OF THE FOOTREST PLATFORM
fig. 54
press it downwards.
fig. 55
SAFETY BELTS
fig. 56
the position is not correct, extract the belts from the first pair
fig. 57
the ends of the waist one.
fig. 58
buckle.
fig. 59
rings (P39) and, when being used, it must be adjusted in or-
fig. 60
CAUTION! The inobservance of this precaution may result
in the falling or sliding out of the baby with a resulting
risk of injury.
HOOD
fig. 61
(P40) in correspondence of pins (P41) on the side pipes.
Once inserted, close the two corresponding flaps. Then at-
tach button (P42) to the backrest of the stroller.
To remove it, perform the above described procedure in op-
posite sequence.
fig. 62
wished position.
MAINTENANCE OF THE HOOD LINING
fig. 63
rect maintenance. Unhook the buttons (P43) positioned on
both sides of the hood articulated joints (P44).
fig. 64
fig. 65
(P46) rear tapes in the proper guides on the internal lining.
fig. 66
ticulated joints (P44
button up the corresponding press studs (P43).
fig. 67
be placed on the front.
It is possible to adjust the backrest to 4 positions;
Hook the handrail (P5) with covering, inserting the
The handrail can be opened on one side or com-
To lower the platform act on both levers (P38) po-
To lift the platform just pull it upwards: it will block
Fasten the ends of the waist belt to the central
To fix hood (P8) to the stroller, place two clamps
The hood covering can be removed to allow its cor-
Release the front (P45) and rear (P46) tapes from
To reassemble the lining, insert the front (P45) and
Then, insert the tapes in the seats (P47) on both ar-
WARNING: shortest binding (P45) must always
P37) present
-