Jennair JS42NXFXDE Guía Para La Instalación página 21

4. Adjust the "L" brackets, so that the wood filler piece is flush
with the bottom of the soffit. Completely tighten the screws.
A
B
C
A. Top grille filler
B. "L" bracket
C. Grille mounting plate
Side View
A. Top grille filler
B. Soffit
C. Airflow
Panel Kit Models
WARNING
Excessive Weight Hazard
Use two or more people to move and install
panels.
Failure to do so can result in back or other injury.
1. Align top grille vent (provided in the door kit) with the bottom
edge of the soffit. Use as a template, and mark where to drill
the holes.
A
B
C
D
E
D. Grille panel
E. Door panel
2. Using the slotted hex-head screws (provided with refrigerator),
attach the top grille vent to the soffit.
A. Top grille vent
B. Slotted hex-head screw
Side View
A. Soffit
B. Airflow
Predrill Panels (custom wood panels only)
IMPORTANT: The custom panel template shipped with the
refrigerator can be used for either a 3/8" (0.95 cm) or a
1/8" (0.32 cm) reveal installation.
The drilling templates are used only for custom wood overlay
■
panels.
The drilling templates are double-sided.
■
The drilling holes are precut into the template.
■
1. On the template, locate the diagram of your refrigerator. Then,
follow the letters and colored arrows to correctly place the
drilling template on the back side panels.
NOTE: Check the direction of the arrows to determine which
holes to mark when the template is aligned at the top of the
panel and which holes to mark when the template is aligned at
the bottom of the panel.
2. Predrill pilot holes into the wood rails bordering the doors and
top grille panels.
Prepare Panels (custom wood panels only)
Door Panels
1. Place panels on a firm, covered, flat surface with the front
facing down.
A
B
A
B
C
D
C. Grille panel
D. Door panel
21