Set-Up/Fitting To The Wall; First Use - Nevadent NAZ 2.4 C3 Instrucciones De Uso

CAUTION – PROPERTY DAMAGE!
The appliance may only be recharged with the supplied
►
charger .
Otherwise, the appliance could be irreparably damaged!
Operate the appliance only with the original accessories
►
supplied .

Set-up/fitting to the wall

NOTE
In damp rooms, especially in the vicinity of water (bath), the charger 8
must be set up so that it cannot accidentally fall into the water .
Place the charger 8 on a clean and level surface .
Ensure the charger 8 cannot fall into water, such as a bath or sink .
You can also fit the charger permanently to the wall:
1) Mark two drill holes on the wall at a distance of approx . 44 mm from each
other . Check to ensure that there is a mains power socket in the immediate
vicinity .
2) Before drilling the holes, check to ensure that there are no electrical cables or
water pipes behind the markings .
3) Use a 5 mm drill bit to drill the marked holes and push the supplied wall
plugs e in .
4) Screw in the screws r so that the heads protrude a few millimetres . Hang
the charger 8 with the drill holes 9 over the two screws r and ensure
that the screws r slide into the slots . The charger 8 should lie flush against
the wall . You can adjust the distance to the wall and compensate for any
unevenness in the wall by screwing or unscrewing the screws .
5) Hang the charger 8 on the screws r .
6) Ensure that the power cable is not trapped and that it lies properly in the
cut-out .

First use

NOTE
Before starting to use the appliance, check that it is in fault-free condi-
tion . You must not use the appliance if it has any faults .
1) Insert the power plug into the socket .
2) Before the first use, clean the new brush heads 1 with clear water .
NAZ 2.4 C3 GB │ IE │ 19 ■