Placement; Drainage; Supply Line Assembly; Maintenance - Conglom QL029 Manual Del Usuario

Installation (continued)

PLACEMENT

Push the cabinet (A) against the wall. Position cabinet as desired. If required, level it by adjusting the four leveling legs and checking the
alignment of the sink (B) using a carpenter's level.
IMPORTANT: Secure the cabinet to the wall using hardware best suited for your wall type. Failing to do so could result in
property damage or personal injury.
Use silicone sealant to seal the sink to the wall and any adjacent surfaces to keep those surfaces dry. Failing to do so
could result in moisture damage.

DRAINAGE

The tailpipe (not supplied) previously installed to the drain can now be connected to your household plumbing. In some cases, your
household plumbing will have to be modified to ensure proper drainage. If so, please consult a licensed plumber to complete needed
modifications.
SUPPLY LINES
Connect the supply lines to your home's water supply as per manufacturer's
instructions .
Open the hot and cold water supply valves and check to make sure they have
been installed to appropriate inlet ports . Check for leaks . Run hot and cold water
uninterrupted for about one minute to remove any residue from the lines .

Maintenance

CARTRIDGE REPLACEMENT

- Turn off the water supply to the faucet .
Take off the plastic temperature indicator (1) by hand, then use the
-
hex key to remove the set screw (2) and pull the handle body (3) off.
Unscrew the decorative cap (4) and retaining nut (5), making sure
-
not to damage the threads .
Pull out the cartridge (6) and replace it with a new ceramic
-
cartridge .
Reinstall the retaining nut (5) making sure the cartridge (6) is
-
properly seated within the faucet body (7).
Reinstall the decorative cap (4) and tighten gently by hand.
-
Reinstall the handle body (3) and lock it in place using the hex key
-
and the set screw (2). Do not over tighten.
Reinstall the temperature indicator (1) into the handle body (3)
-
making sure the red is on the left and the blue is on the right .
- Turn the water supply to the faucet back on .
- Operate the faucet to make sure everything works correctly and
check for leaks .
QL029
Temperature indicator (1)
Retaining nut (5)
Cartridge (6)
Faucet Body (7)
10 10
Set screw (2)
Decorative cap (4)
Handle
Body (3)