GRABBER GR871 Manual De Instrucciones página 8

Sierra trozadora con abrazadera de cambio rápido (quick-change) de 355 mm (14 pulg.) para trabajo pesado
Ocultar thumbs Ver también para GR871:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: Risk of property damage. Do not allow cordset to come
into contact with deflector or sparks as damage to cordset may
occur.
Vise Operation (Fig. 5)
The vise has a quick travel feature. To release the vise (F) when it is
clamped tightly, turn the crank (H) counterclockwise one or two times
to remove clamping pressure. Lift the vise lever (I) up. Pull crank
assembly out as far as desired. The vise may be shoved into work
without cranking. Lower vise lever then tighten vise on work by using
crank.
FIG. 5
R
FORWARD
T
E
Fence Operation (Fig. 5)
WARNING: To reduce the risk of injury, turn unit off and discon-
nect machine from power source before installing and removing
accessories, before adjusting or changing set-ups or when making
repairs. Be sure the trigger switch is in the OFF position. An
accidental start-up can cause injury.
The fence (E) requires no tools to adjust. The quick-release clamp
lever (T) unlocks and locks the fence. When the lever is rotated fully
forward, the fence is unlocked. The fence can then be freely moved
forward, backward or rotated to allow for the best cutting position for a
new wheel and as the wheel wears.
I
H
F
Rotating the lever fully to the rear locks the fence in position selected.
If the bottom leg of the lever is not horizontal (parallel to the base),
the fence is not locked. Lever will only lock fence when there is strong
resistance to moving it to rear. If resistance is light, adjust clamping
force by tightening slightly the two bolts (R) holding the fence to the
base. Test by reclamping and attempt to move fence.
Fence Angle Adjustment (Fig. 6)
WARNING: To reduce the risk of injury, turn unit off and discon-
nect machine from power source before installing and removing
accessories, before adjusting or changing set-ups or when making
repairs. Be sure the trigger switch is in the OFF position. An
accidental start-up can cause injury.
The angle adjustment indicator is part of fence clamping system. Align
the desired angle indicator line with the edge of the slot in base.
FOR A MORE ACCURATE SQUARE CUT
1. Unlock the fence.
2. Push the arm down until the wheel extends into the base.
3. Place a square against the wheel and adjust the fence against the
square.
4. Lock the fence into position.
FIG. 6
ANGLE ADJUSTMENT
INDICATOR
SLOT
EDGE
6
SQUARE
WHEEL

Publicidad

Tabla de contenido
loading

Productos relacionados para GRABBER GR871

Tabla de contenido