Pairing A Bluetooth Device Using Nfc - ION Garage Rocker Guia De Inicio Rapido

Pairing a Bluetooth Device Using NFC

NFC (near-field communication) allows data exchange from devices, such as pairing, by gently
bumping them together. Check in your device's manual to see if this feature is supported.
To use NFC to pair with Garage Rocker:
1. In order to use NFC, your device must be turned on and unlocked.
2. Enter your device's Settings menu and check that NFC is turned On (one-time step).
3. Power on Garage Rocker.
4. Touch and briefly hold your device to the NFC logo.
5. Follow the pairing instructions that appear on your phone. If a passcode is required, enter
"0000".
6. To unpair, gently bump your device against the NFC logo located on Garage Rocker's top panel.
Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical instrument,
or microphone. Also, try to reduce the overall volume of Garage Rocker using the Master Volume
knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the
bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably feedback.
Point the microphone away from the speaker.
If there is poor AM reception: To adjust AM reception, move entire unit.
If you can't hear the microphone over the music volume: Turn down the music volume from your
source.
If you can't play music from a flash drive: The USB port is only for charging USB devices.
7