Transport, Commissioning And Decommissioning; Transport; Commissioning - Hupfer SPA/EB-1 Manual De Instrucciones

Chapter 4
Page 18
4

Transport, Commissioning and Decommissioning

4.1

Transport

CAUTION
The mobile bain marie is delivered as an assembled unit, i.e. it is completely assembled including the heat-
ing.
When loading, use only hoists and load lifting devices approved for the weight of the mobile bain marie. Only
transport vehicles approved for the weight of the appliance may be used.
The scope of delivery is specified in the shipping documents in accordance with the valid purchase agree-
ment and included with the delivery item.
4.2

Commissioning

DANGER
Remove the original packaging and check whether the appliance is complete and undamaged. Do not put a
defective appliance into operation under any circumstances and inform the supplier immediately in such a
case.
Always place the mobile bain marie on firm and level floors when unpacking and operating it. Apply the total
brakes on both swivel castors to secure the appliance against rolling away.
INFO
The mobile bain marie should be thoroughly cleaned with a soft cloth before putting it into operation for the
first time. Ensure that the appliance is clean and dry before putting it into operation.
The following appliance functions must be checked before putting it into operation:
§
the functioning of the total brakes
§
the functioning of the controls and heating.
Mobile Bain Maries
SPA/EB-1 | SPA/EB-2 | SPA/EB-2F | SPA/EB-2LS | SPA/EB-3 | SPA/EB-3F | SPA/EB-3LS | SPA/EB-4
Damage to appliances caused by improper transport
Appliances should be safely secured when transported off site inside a vehicle
such as a truck. The total brakes are not suitable for securing the appliances
when they are transported in a vehicle.
If the appliances are not secured properly, there is a risk of damage to proper-
ty and personal injury caused by squashing.
Secure each individual separate appliance using suitable transport securing
devices.
Hazardous electrical voltage
Electrical current can pose a considerable threat to life and physical well-
being and may lead to injuries.
Before putting the appliance into operation, check whether the power supply
indicated on the rating plate (230V / 50 Hz) corresponds to the local power
supply. If this is not the case, do not put the appliance into operation.
Do not use any extension leads in wet areas.
Disposal of packing material
The packing material consists of recyclable materials and can be disposed of
accordingly. The different materials should be separated and disposed of in
an environmentally friendly manner. The local agencies responsible for dis-
posal must be contacted regarding removal.
Transport, Commissioning and Decommissioning
Transport
4330002_A2