Operation; Stacking Platform Adjustment; Spring Adjustment - Hupfer BPN-P Manual De Instrucciones

Section 5
Page 16
5

Operation

CAUTION
5.1

Stacking platform adjustment

The appliance must be adjusted if one or more of the following crockery parameters is changed: diameter,
edge length, height, stack height or weight.
5.1.1

Spring adjustment

CAUTION
CAUTION
Before loading the appliance, the dispensing height must be adjusted to the type of crockery used. The dis-
pensing height is adjusted by attaching or replacing tension springs.
The dispensing height must be adjusted to ensure that the uppermost items of crockery are constantly
moved upwards over the entire lift to an unvarying dispensing height between 0.59'' (1.5 cm) and 2.36'' (6
cm) above the upper rim of the housing.
Step 1 - Checking the spring adjustment
§
Load a stack of 15 to 20 items on to the stacking platform to test the dispensing height.
§
Wait for the system to self-adjust.
If the dispensing height of the crockery stack is about 1.97'' (2 cm) above the upper edge of the appliance,
the spring system is adjusted correctly.
If the stack drops down only a little or not at all, the dispensing height must be altered by adjusting the
springs.
Platform dispenser for porcelain and lids
BPN-P | BPN-D
Personal and property damage due to improper adjustment
The springs are exposed if the stacking platform is pressed down by hand.
Reaching into the gaps of the exposed springs may cause hand injuries.
Never press the stacking platform down by hand.
Be careful when attaching and detaching the springs. Pay particular attention
to the ends of the tension springs when adjusting springs on sharp edges.
Personal and property damage due to improper adjustment
When the dispensing height is exceeded, there is a risk of accident or injury
due to tipping of the inserted stacks. If the level of the stack falls below the
dispensing height, fingers may be injured if caught when removing dishes.
Adjust appropriately the dispensing height by attaching or detaching the
springs. When adjusting springs on sharp edges, pay particular attention to
the ends of the tension springs. Proceed with care.
Risk of injury
Be careful when attaching and detaching the springs.
Pay particular attention to the ends of the tension springs when adjusting
springs on sharp edges.
Operation
Stacking platform adjustment
91365304_A0