Features; Package Contents; Cable Installation - LEGRAND C2G30019 Manual

D 4K HDMI® HDB
UAL
P T - 4K 60H
LATE RANSMITTER
F
EATURES
Two HDMI inputs, One USB-C input and one HDBT output
•
Extend 4Kx2K at 60Hz (4:2:0) up to 130ft and 1080p at 60Hz up to 230ft with Cat 6a/7 cable.
•
Extend 4Kx2K at 60Hz (4:2:0) up to 115ft and 1080p at 60Hz up to 200ft with Cat 5e/6 cable.
•
Supports automatic switching
•
Additional analog audio input pass-through allows for audio distribution to the HDBT
•
receiver side
High-speed USB 2.0 pass-through over HDBT up to 230ft
•
Supports firmware updates through the USB Micro-B port on the Transmitter
•
One-way Power over HDBaseT (PoH), so that the wall plate can be powered by receiver
•
C I
ABLE NSTALLATION
Note: Before installing cables, please ensure the unit is disconnected from the power source.
1. Connect Dual HDMI IN: Connect up to two HDMI source devices (e.g. Laptop, Blu-ray player, etc.) to HDMI IN 1 and HDMI IN 2 of the
transmitter using a high-quality HDMI cable.
2. Connect USB-C IN: Connect a USB-C source device (e.g. Laptop, tablet, etc.) to USB-C IN of the transmitter using a USB-C cable.
3. Connect USB-B HOST PORT: Using the included USB-A to B Cable, connect the USB-A end to source device (e.g. Laptop, etc.) and connect the
USB-B end to the USB HOST PORT on the wall plate transmitter.
4. Connect HDBT: Connect HDBT Out of the transmitter to the HDBT IN of the receiver using a Cat 5e/6/6a cable.
5. Power on all attached devices.
T + USB-C®, 3.5
ASE MM
Z
, USB-B C
AND OVER AT
3
E W
XTENDER ALL
P C
ACKAGE ONTENTS
1 x Wall Plate Transmitter
•
with Screws
1 x Wall Plate Plastic Panel (2‐Gang
•
US, with Screws)
1 x USB-A to B Cable
•
1 x 4-Pin Phoenix Male Connector
•
1 x Manual
•
( ( ) )
US US
( )
US