Setting The First Printing Line (Tof) - TallyGenicom 7265 Manual De Usuario

Quick start-up
Setting the first
You can use the TOF function for setting the position of the first printing line for each paper
printing line (TOF) source and each menu individually.
Before using the TOF function (if fanfold paper is used), you should first set the tear position
(see above).
Adjust Paperway
Menu Char Online
1 2 3 4
Setup
TOF
Head Tear Online
1 2 3 4
Setup
B
A
FormAdj= 12/72"*
Set < > Exit Online
1 2 3 4
Setup
Open the top cover.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key. The printer performs a form feed.
The paper is fed to the position where the bottom edge of the
first printing line A is aligned with the tear edge of the top
cover B. The factory setting for the first printing position
(TOF) is 12/72".
Press the < (2) or > (3) key to move the first printing line to the desired posi-
tion. You can set values from 0 to 220/72" for fanfold paper or for single
sheets.
Settings
21