Selecting Character Density And Font - TallyGenicom 7265 Manual De Usuario

Quick start-up
Selecting character
You can use the CPI (= Characters Per Inch) key in setup mode to select the number of char-
density and font acters per inch to be printed. You can use the Font key to select resident fonts.
Adjust Paperway
Online
Menu Char
3
1 2 4
Setup
Font CPI
Online
1 2 3 4
Setup
10 CPI *
Set < > Exit Online
1 2 3 4
Setup
ROMAN NLQ
Online
Set < > Exit
1 2 3 4
Setup
Adjust Paperway
Menu Char Online
1 2 3 4
Setup
The selection made will not be retained after switching off the printer. For more details on
how to set the character density permanently, please refer to the Reference Manual on the On-
line CD-ROM.
Press the Setup key, then the Char (4) key.
Press the CPI (3) or Font (2) key (in our example, press CPI).
Use the < (2) or > (3) key to set the desired character density. Confirm the se-
lection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
If you pressed the Font (2) key, use the < (2) or > (3) key to select the desired
font. Confirm the selection by pressing the Set key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
Press the Setup key. The printer returns to the initial status. It is also possible
to press the Online key. The printer then changes directly to online mode.
Settings
23